Recent content by mikemcphail

I have a Tekonsha Prodigy controller (got it in '05). My truck got totalled ('05 silverado 2500 duramax) and I replaced it with an '07 Sierra 3500 dually. Will the cable from the old truck (Tekonsha part # 3015) work in the '07 GMC? The closest info I can find says, "Adapter is wired for GM...

Hey, thank you all so much! Got the fixture off, replaced the bulb, & even found & replaced the fuse that was preventing my slides from working...all thanks to the members of these forums. What an invaluable resource! Gotta tell you, though, I'm not real crazy about this Komfort 3530FBH. Every...

Thank you all very much! I just pulled it down & twisted the glass cap off (wish this was in a book somewhere). Now if I may impose upon you again...how do I identify this bulb? There are no markings that I can see - and I used a magnifying glass! Here's a photo (see attached):

Alright, this is going to sound ridiculous, but I can't figure out how to get to the bulb. These light fixtures (2011 Komfort 3530FBH 5th wheel) are round, almost flush with the ceiling with a little bulge for the bulb. But the surface has no holes! I can pull the fixture out a little more than...

Found it! thanks to your tip about the inline fuse & comments about the controller usually being in the same compartment as the battery. I was staring at this module near the battery but nothing looked like a breaker, so I finally did a search for the brand name that was on a small module that...

Wow, Thanks! I'm calling Bob tomorrow. Thanks again, Mike

No, unfortunately, I don't. I looked through all the reams of documentation and there isn't any information about the slides. I downloaded all the manuals from the support section of Komfort's site, and the best guess I have is that it's a Lippert, but I can't tell which one. I sure would like...

It has 3 slides and none work (they worked fine just before we came home). Also, the power awning doesn't work. All the other electrical works fine.

My slide outs are dead on this new rig & I suspect a breaker or fuse. Unfortunately, the fuse panel is behind the slide out (great design!) and I can't get to it. Could there be a separate breaker panel somewhere? Also, on a related note, anybody happen to know where I can find the drive motor...