Recent content by pappi49

Well, after reading all your comments he has decided to start all over again. Going to take a hard look at trailer and or truck to get the best fit. If i remember I wil update when he has made a decision. Thanks for the information.

Doing some research for a friend. He is considering the purchase of a 30 ft. travel trailer and is planning on pulling with a 145 inch wheel base truck. Everything I have read says that in order to pull this trailer a 150 inch wheel base truck is better. Do you really think a 3-5 inch differance...

This is the one we use. A little pricy but like a lot of you, the bag chairs just were not cutting it. Here is the linc from Camping world; Summit Padded Folding Outdoor Rocker

Just thought I would up date everone on my troubles with my Norcold N611V. As you may recall I was having trouble with my fridge freezing everythiing. This was after replacing the thermistor, and adjusting it per the manual. Nothing I tried seemed to have any affect at all on the temp. Whgile...

Thanks for all of the explanations. For some reason I was under the impression that the temp readings were to be taken as an absolute. Moreso since the temp reading can be set during setup.

Not real sure where this goes but if it needs moved please do. I must have too much time on my hands as while reading through another one of the forums I belong to I got to thining about the tpms temp sensor. Can some one tell me exactly how the temp sensor can give a accurate readinig. I am...

Gary, I apologize if I came across as a smart a$$ in my previous comment. That was noat my intent, Here is the page from my owners manual tahat gives the proper instructions for adjusting the thermistor. You may have to enlarge it to make it legible.

Gary, please note; OK you have one of the FEW N611V models that has Auto Temp Control vs adjustable temp settings On that Version of the N611 you can relocate the thermistor 3-4 fins at a time to have MINOR affect on overall temps Moving to the right...warmer temps Moving to the left.....colder...

I have adjusted the thermmistor as far to the right as it will go and there is no change. Also,the fridge is cycling as it should but the temp range is too high to not freeze. I am not sure of the exact temp. but I do know that is was running well below 30 degrees F. I believe that it would go...

Norcold N611V I have looked all over the web and have this posted on another forum but I am having no luck. Can someone help me out with information regarding freezing temps in the N611V NorCold fridge. The "V" being the key part of the fridge. I can find all kinds of info on the N6xx but...

I am already planning on doing the roof and all intrusions with Eternabond. The Seal Tite is made specifically for corners along with normal caulk or butyl tape. Dicor sells a complete kit that includes the tape (2 rolls) and six tubes of Dicor Products Clear Cap Sealant.

Just wondering if anyone has re-sealed the corners of your rig with Dicor SealTite tape.I purchased every thing that was needed but to be honest I am a little nervous about starting this project. I have watched alot of you tube videos about this and it does not look all that hard but I am still...

I will, as soon as it gets above 30 degrees here in Ky.

Just to let everyone know, I went inexpensive and purchased the Beech Lane tape. Got it in a 4" by 50 ft. roll and it comes with a lifetime mfg. warranty. Really dont know exactly what it covers as I haven't/din't read it yet but it's nice to have the piece of minnd. Thanks to all for the help...

I want to thank everyone for their suggestions. I have not purchased the tape yet and actually that is a good thing. Something I thought about as I was getting ready to purchase the tape is what width of tape are most of you using.My main objective is to get the roof sealed at the point that...