Recent content by wbilotta

All they have done so far is pull one valve cover while the genset was still in the RV and then they pulled the genset. 

I took it in to have them check it out.  They quoted me 5200.00 for a new unit installed, then called back the next day to say they made a mistake, that price was to only replace the engine, new price would be 7700.00 I declined.  They already pulled the generator so my brother and I are going...

When I changed the oil it looked fine, no signs of metal.  I'm waiting to hear back from the shop after they drop the genset.

Older unit circa 2001, Onan 7HGJAB-900A.  It will only run for a few seconds then gives error code #32 which could be a litany of things.  So I changed the oil, no help.  Batteries are topped off.  Connections are tight. Took it to a dealer and he said they pulled the right side valve cover...

Cranks as long as I hold the START button but does stop cranking after a few second even if I continue to hold the START button Just changed the oil and filter, oil is full.  The cranking does not slow down so I don't think it's a low voltage problem w/ the batteries but I will connect a...

Genset cranks while I hold the Start button, shuts down and the start button light flashes three times.  I push Stop and then the light flashes three times then twice indicating error code 32 which is low cranking speed or oil issue. The genset is cranking just fine and will crank as long as I...

If my Dometic refer sits for a while I have to go outside, pull the cover, bleed out the propane line at the gas valve in the refer.  Somehow the propane is leaking out and being replaced with air.

22 years twisting nuts and I have never broken a lug in a panel.  Sometimes corrosion will fuse a screw in place.  I tighten till I think it's tight enough and then stop. And I have never seen an electrician break out a torque screwdriver on a jobsite. 

Not sure if this is the correct forum for this question.  My 2001 Intruder has a Thetford Aqua Magic Aurora and it suddenly will not hold water.  With the flush lever depressed I felt around the rubber flange and towards the front I can feel that the gap is a bit wider and this is where the...

So I extended the piston, sprayed it with a lubricant, wiped it down, cycled it.  I did all of this several times, no help.  The piston will retract but I have to help it out with some leverage. I called HWH and was told a technician will call me back in 1.5 weeks :\  The lady I spoke with...

I didn't but we did have a renter use the RV this weekend.  If the rod was bent I would think I wouldn't be able to retract it with leverage.

I'm looking for campgrounds within a three hour radius of Joliet IL.  I have three young kids so campgrounds with things for the kids to do would be preferable.

I'm baffled as to why the springs are not retracting the jack

2001 Damon Intruder 369, not sure which HWH system I have.  It has a joystick controller next to the driver's seat.  There are two levers that you push away from the center when you need to operate the jacks and the center joystick controls the jacks. Driver's side rear did not retract all the...

We have a 2001 Damon Intruder 369 and it came with a kitchen table and four chairs.  I would like to replace this with two seats and a table that converts into another sleeping area.  Any suggestions as to where I can look ?