phil-t
Well-known member
Have not seen, in this thread, where you got the trouble codes from the genset. Nor do I see where you posted your specific model #.
Restoring Fault Code Blinking ? The fault code stops blinking after five
minutes (15 minutes, Series HGJAA). Press Stop three times within five seconds to
restore blinking. Note that the last fault logged will blink, even after the
condition that caused the shutdown has been corrected.
Fault Codes
The genset controller provides extensive diagnostics by causing the status indicator
light on the Control Switch to blink in a coded fashion. Following a fault shutdown,
the indicator light will repeatedly blink one, two, three or four blinks at a time.
? One blink indicates shutdown due to high engine coolant temperature.
? Two blinks indicates a low oil pressure fault.
? Three blinks indicates a service fault. Press Stop once to cause the
two-digit, second-level fault code to blink. (Pressing Stop again will stop the
blinking.)The two-digit code consists of 1, 2, 3, 4 or 5 blinks, a brief pause,
and then 1 to 9 blinks. The first set of blinks represents the tens digit and the
second set of blinks the units digit of the fault code number. For example,
Fault Code No. 36 appears as:
blink-blink-blink?pause?blink-blink-blink-blink-blink-blink? long pause?
repeat
? Four blinks indicates that cranking exceeded 30 seconds without the
engine starting.
Note: Fault Code Nos. 3 and 4 are first level faults. Avoid interpreting them
as second-level Fault Code Nos. 33 and 44, which have not been assigned
as fault codes.
Restoring Fault Code Blinking ? The fault code stops blinking after five
minutes (15 minutes, Series HGJAA). Press Stop three times within five seconds to
restore blinking. Note that the last fault logged will blink, even after the
condition that caused the shutdown has been corrected.
Fault Codes
The genset controller provides extensive diagnostics by causing the status indicator
light on the Control Switch to blink in a coded fashion. Following a fault shutdown,
the indicator light will repeatedly blink one, two, three or four blinks at a time.
? One blink indicates shutdown due to high engine coolant temperature.
? Two blinks indicates a low oil pressure fault.
? Three blinks indicates a service fault. Press Stop once to cause the
two-digit, second-level fault code to blink. (Pressing Stop again will stop the
blinking.)The two-digit code consists of 1, 2, 3, 4 or 5 blinks, a brief pause,
and then 1 to 9 blinks. The first set of blinks represents the tens digit and the
second set of blinks the units digit of the fault code number. For example,
Fault Code No. 36 appears as:
blink-blink-blink?pause?blink-blink-blink-blink-blink-blink? long pause?
repeat
? Four blinks indicates that cranking exceeded 30 seconds without the
engine starting.
Note: Fault Code Nos. 3 and 4 are first level faults. Avoid interpreting them
as second-level Fault Code Nos. 33 and 44, which have not been assigned
as fault codes.