doubravsky
Active member
I pulled up to a campsite that was a bit of a slope downward towards the back. Started the auto leveler system.. and it lowered the rear jacks ... started to give the "unable to level" message, and then a "low voltage" message.
So now I'm stuck not level... and not sure how to fix the error message.
When I pulled up and started the auto level... I was running the generator/ and the AC.
Turned off AC... waited 10 minutes... no change. Plugged into shore power.... no change.
Would the auto leveler be hooked to the coach batteries or the engine battery? Did running the auto level with the AC on cause it?
Will the error message reset itself or is there something I can do to reset it?
So now I'm stuck not level... and not sure how to fix the error message.
When I pulled up and started the auto level... I was running the generator/ and the AC.
Turned off AC... waited 10 minutes... no change. Plugged into shore power.... no change.
Would the auto leveler be hooked to the coach batteries or the engine battery? Did running the auto level with the AC on cause it?
Will the error message reset itself or is there something I can do to reset it?