kbfeip
Well-known member
Today I installed a brand new furnace. It tries to light repeatedly, but can't seem to get there. Fan spins, igniter works, fires up for a few seconds, and then you can hear what sounds like a solenoid valve shutting of. (Gas valve?)
If I let it, most of the time it will run like this continuously without shutting down, trying to light every few minutes or so. A few times it did shut down an the diagnostic code read: Ignition fault code." The last time it shut down and read: "Internal control Failure."
I had the gas shut off prior to the install. I've run the water heater, the stovetop burner, and the refer. (Although the refer did take quite a while to light) The stovetop burner flame does flash orange randomly around the perimeter of the burner occasionally...air in the lines?
Suggestions please? If this sounds like air in the supply line to the furnace, suggestions on how to clear it?
Should I pour gasoline into the burner area to prime the furnace? (KIDDING!)
HELP!
If I let it, most of the time it will run like this continuously without shutting down, trying to light every few minutes or so. A few times it did shut down an the diagnostic code read: Ignition fault code." The last time it shut down and read: "Internal control Failure."
I had the gas shut off prior to the install. I've run the water heater, the stovetop burner, and the refer. (Although the refer did take quite a while to light) The stovetop burner flame does flash orange randomly around the perimeter of the burner occasionally...air in the lines?
Suggestions please? If this sounds like air in the supply line to the furnace, suggestions on how to clear it?
Should I pour gasoline into the burner area to prime the furnace? (KIDDING!)
HELP!