Hi all
I have a 2006 Itasca Ellipse. 3 slides. The last time I leveled it, I raised the front, then the back, when I went to raise the drivers side it started to raise then the pump stopped, I pushed the button again and it started to lower instead of raising. I could hear the fluid going back into the reserve. I can raise the front, back and passenger side but when I try the drivers side it just lowers. The slides work well no problem there. In the past I have had a few times where I had to push the buttons on the control panel a couple of times to get them to work. I had to change the shuttle valve last year because the slides where very slow to move, that corrected the problem. I have contacted HWH, filled out the request form 3 times over the last month and no reply from them. Just wondering if anyone else has had this problem before.
Thanks
John Braidwood
I have a 2006 Itasca Ellipse. 3 slides. The last time I leveled it, I raised the front, then the back, when I went to raise the drivers side it started to raise then the pump stopped, I pushed the button again and it started to lower instead of raising. I could hear the fluid going back into the reserve. I can raise the front, back and passenger side but when I try the drivers side it just lowers. The slides work well no problem there. In the past I have had a few times where I had to push the buttons on the control panel a couple of times to get them to work. I had to change the shuttle valve last year because the slides where very slow to move, that corrected the problem. I have contacted HWH, filled out the request form 3 times over the last month and no reply from them. Just wondering if anyone else has had this problem before.
Thanks
John Braidwood