Shower and sink moldings

[Scoundrel]

Here I go again, I promise this will be my last question......

I was looking over the corner moldings in the shower and they are cracking and basically degrading to chips and falling off.
I believe back in 1992 they were some kind of adhesive backed vinyl corner molding. I assume at some point you all have to replace the molding as well. My question is do you replace the molding with new molding or do you use a silicone bath and sink caulking??

Thanks for your help!

 

[Gary RV_Wizard]

Standard tub & tile caulks work fine. Or any silicone-based caulk.  You can also use the vinyl stick-on stuff, but make sure the joint is sealed with caulk behind it. The tape is just decorative and is used mostly to cover dirty caulk.