BikerFlex&HappyJen
Well-known member
- Joined
- Mar 25, 2017
- Posts
- 197
denmarc said:Wondering about one thing...
How did hubby get the subfloor under the sole plate of the existing walls? Reason I ask is I might have to do something similar in my TT on a small section next to the super slide?
Otherwise, it looks like you guys are well on your way to enjoying the sweat equity you have been putting into this project.
I'm proud of ya!
Keep us posted.
DH used two jacks on each corner when we had the bottom aluminum siding and the back siding wall off. He use the jacks to hold up the back/side wall and then we slid the subfloor between the wall and the bottom support frame. It took some hammering to wedge it in there, but it worked. Once it was between the frame and the wall pieces, he was then able to remove the jacks and finish hammering it into exact place. We did this large back piece installation from the outside. The two pieces inside he had to use some wedges using a huge screwdriver and also a small crow bar on each side to lift just enough to slide the subfloor in between. The interior ones were much easier after we had the main piece toward the back into place. Here's a picture from earlier that kind of shows how he did the back piece from outside. You can see the large piece of subfloor that had been put in between but it's not yet in the exact place. After this picture, he removed the jacks and then hammered the large piece back and inward where it finally needed to be.
Hope this helps!