I have a 2008 Mandalay 40G, looking to reset the Master Code and need to find the I/O Learn Module to short out S1 pins.
Reset the keypad to the default state by performing the following procedure: • Cycle (short then open) the S1 pins of the I/O module learn connector. There will be a three-second beep. • Enter a new five-digit code; this will be your access and authority code. • Enter the new code again. • The existing code will only erase if you properly enter the new one. • The code is stored in position one.
I don't know where this module is located, any help at its location would be great.
Reset the keypad to the default state by performing the following procedure: • Cycle (short then open) the S1 pins of the I/O module learn connector. There will be a three-second beep. • Enter a new five-digit code; this will be your access and authority code. • Enter the new code again. • The existing code will only erase if you properly enter the new one. • The code is stored in position one.
I don't know where this module is located, any help at its location would be great.