Getting a bit frustrated, but I have tried just about every type of grease gun fitting I can find - 90 degree, needle tip, etc and I just can't get my gun on to the zerk on any of my u joints.
I'm looking at removing the 3 part driveshaft just enough to reach the zerks (I had these replaced when I had the transmission replaced about 3 years ago). Any hints or procedure for removing the driveshaft?
thanks, ryan
I'm looking at removing the 3 part driveshaft just enough to reach the zerks (I had these replaced when I had the transmission replaced about 3 years ago). Any hints or procedure for removing the driveshaft?
thanks, ryan