engelwood39
New member
Hello all! I am new to the forum and a new RV owner as of yesterday. I got a 1999 Sunseeker that needs some TLC. I am excited to be part of the community.
Here is the problem I am having. The generator (a Generac q55g) is not starting. It just clicks on time.
Here is what I know:
>battery is good, tested with a load tester
>solenoid is getting 12v and no significant voltage drop off when start is pressed.
>I did jump off running truck directly to the solenoid battery side.
>solenoid output is 12v when start is pressed.
I feel like this leans me towards starter being the issue, can anyone give me any input or testing I should run.
Side note, I saw something stating that there wire labeled 15 on the engine control board that should be getting 12v, my wires are a little hard to read, but I think it us the bottom wire on the harness and if so I believe I am not seeing any voltage on that leg. Does that mean I am not getting power yo the control board?
Here is the problem I am having. The generator (a Generac q55g) is not starting. It just clicks on time.
Here is what I know:
>battery is good, tested with a load tester
>solenoid is getting 12v and no significant voltage drop off when start is pressed.
>I did jump off running truck directly to the solenoid battery side.
>solenoid output is 12v when start is pressed.
I feel like this leans me towards starter being the issue, can anyone give me any input or testing I should run.
Side note, I saw something stating that there wire labeled 15 on the engine control board that should be getting 12v, my wires are a little hard to read, but I think it us the bottom wire on the harness and if so I believe I am not seeing any voltage on that leg. Does that mean I am not getting power yo the control board?