Rene T
Site Team
That’s awesome. Thanks for getting back to us.
I wonder what that piece does and how did it get bent
I wonder what that piece does and how did it get bent
Last edited:
I think as stated it's a "slider" support to assist the two tracks on fore and aft. As the shelf comes out when loaded I am guessing it could sag without that support.That’s awesome. Thanks for getting back to us.
I wonder what that piece does and how did it get bent
It was getting the best of me so I went out one more time and took a real close look. If the Op looks at the backside of the square tubing. Go up about 12” and you’ll see a small lever. When you push down on it, it will disengage to pin out of the hole.
Am I glad that’s done. Now what’s next.