Recent content by cruzn57

went to  run up everything, (been sittng for 4+ mos) for the LP regulator leaking, ,in searching for another 2 stage I find 290, 294, 299 , how do you tell which is correct? or does it matter, . I have a horiz tank, on my class C , thanks

was looking for recent info,  not last yrs, as things change in Mexico, worried about safety, etc. Thanks

sorry if its been covered,  but seeking updated info, your experiences? thanks

this is what we use to set  alignment on race cars, it takes a little time to get used to it, http://www.racingplus.com/alignment-tools/longacre/magnetic-c-c-gauge-w-case/1362p10523 for toe settings we use a plate  on outside ea wheel, and measure front and rear...

I like your thinking!  LOL I ordered the off set bushings (ingall 59400) from "Amazon" went out and looked at the front susp. I see what your talking about. guess I should spray it with WD40. need to wait for better weather, I'll camp in this weather, but I'm a fair weather mechanic! been...

Thanks I have a few cold ones sitting here , for your consumption. since its so simple!  LOL really- thanks for the tip, I'll get some ordered, I have a caster/camber gauge I use on the race cars,  I can check it with that.

I have an 89 E350 its pretty good on the highway, but does wander slightly. I added 1/8" toe in and it is alot better, my question is, how is caster set? I believe mine is called twin I beam suspension,  does it require heating and bending? I agree more caster will be beneficial,  but will...

I'd put Toyo at the top of my list,  weighing  cost, quality, waranty, and consumer reports. I just bought some Kumho's as all the others were out of stock, alot less expensive, and reviews are all positive, But I am extremely over cautious about tires, I check before departing, and at each pee...

I'll admit your comments make  me feel better, Thanks for the input! I've known of Kumho for yrs, but little experience. but...... don't go gettin all warm and fuzzy  cause I paid you a compliment!  Ha Ha Ha

I went to  purchase tires recently (I buy from wholesale distributor) I wanted Toyo, but was out of stock, next was uniroyal, out of stock,  Michelin, out of stock ( ok as I thought they were to expensive) this is for 235-85-16 load E finally ended up with Kumho, I did my research on...

for a perculator on the stove, are there any recomendations  on style of coffee,  or Just reg coffee? I'm not a starbucks person, but more like a "gimme some coffee" type! for the record, home is drip style, and whats ever on sale for brand/ type. in the RV, have been known to use instant, but...

Being in So calif,  where over 50% of the population is hispanic,  I'd venture a guess that the OP was very tired of  people trying to lower the standard of living to their former country's level. I sympathize with him, and see both sides of the coin, so to speak. we have stayed at WM, Flying J...

I can only  speak for my own vehicle. I just charged the dash a/c in my 89 ford class C, using digital infared temp gun, on low air speed, air temp was 33 degrees, on high, air temp was 33 degrees, same vent, allowing  unit to stabilize when changing air speed settings, went back after 45 min...

I just installed a brand new electric fuel pump,  logistics  dictate gravity feed , or lack of gravity feed, in this case, pump is even with fuel tank. thanks for additional thoughts, all these older minds are going to waste, this is why I enjoy this forum so much, gives everyone a place to...

most "store brands"  are made by one of the larger manufactures, so using store brands is fine as I see it, older engines ( non roller lifter) will need extra zinc in the oil, as they tend to wear the cam and lifters sooner, I have some older "classic cars" that I add GM EOS to, just for...