Recent content by wvlonglegs

Thanks everyone and thanks for the offer Joe, that is very nice of you but think I am just going to buy the led bulbs. Not sure I have the soldering skills required to do a good job....my hands shake to bad to do any type tedious work. I'd probably have it stuck everywhere I didn't need it to...

Thanks Catrobin. Have you had any problems on the 5 trips you took? Any problems adjusting to driving such a big rv? So far on our short trips, I drove the rv a little and it can be a little intimidating when you're driving in town! Drove back once by jumping on to interstate for just a bit and...

Thanks for sharing the info Ken. I now know where to look for and how to get to the bolts that need checked/tightened. Hope it helps the original poster! I was searching for it in the library and read about replacing the seal but wasn't sure where the bolts were... inside or outside. Thanks...

Well the cargo door latches are all installed except for 3 that still worked. Had to cut them out. Mine install from the inside of panel and door is Styrofoam filled. I cut a hole about 1" back from the frame just big enough to get the old latch out and new one installed. Bought a piece of...

Thank you Catblaster for the offer, but think I am going to switch over to LED's, but do appreciate the offer. John and Cj7365, thank you guys for the info on the bulb prices. I haven't ordered them yet but will soon! Still working on few other projects. Just received and installed (with some...

Thank you John. That's what I will do. Again Thanks!

I watched a video of changing it over to led. Where is best place to get the new led bulbs. Are they very expensive?

Well the other day I worked on my lights on my Winnebago Adventure 34v. By replacing the bulbs I got all to work but one. I replaced bulbs with exact bulbs that I pulled out. The one light that didn't work after replacing the bulbs, I decided I would probably just buy a new 18" 2 bulb light just...

no they didn't!! Looking for my dremel....gonna cut em out!  Very DUMB design!!

Thanks for the response John but mine are made different! I wish it was that simple. My latch sits inside the frame. I can remove the actuator cover and drill out rivets on the ends of the latch but mine has to be pulled back to the actuator hole to be removed. Problem is Styrofoam is sandwiched...

ok, after several trips back and forth to the garage, and checking for any response, this is what I have discovered. 1) I am not the only one who ever replaced one of these latches and ended up cutting the inside panel to install the new latch. During close examination...guess if no problem with...

yes there are some extra rivets on the side frames and bottom frame. I went back out and looked but not sure if I drill them out that it will come apart so was hoping someone else may have tried it before I make another mistake.

Debtise My heart goes out to you and your FAMILY (which includes your animals) for the situation that you are in. In your post you mentioned that due to your circustances you would be changing your life style by moving into an rv. You didn't mention whether you had a piece of land which you...

When we were able to go rving, we had 3 poms, all rescue animals that we took everywhere we went. They were very well behaved and never caused a problem. At that time we used a childs pack and play type play pen. If we were outside and not walking them, they were happy to lie in the pen and be...

I have looked through the site and found some info of replacement of the cargo door latches (slide bolt) but what I have read on how to replace are not like mine. Mine for some reason, the slide bolt is inside the enclosed frame. I tried to replace one some time ago, which didn't go well and...